Neo Download

Canon Pixma MP237 error E07 mean the ink absorber is full. Solution for this problem is reset printer.
Follow instruction below, how to reset Canon Pixma MP237.

1.  Turn off printer
2.  Press and hold STOP/RESET button
3.  Press and hold POWER button
4.  Release STOP/RESET button (POWER button still pressed)
5.  In condition POWER button still pressed, press and released STOP/RESET six times (6x)
6.  Released POWER button
     Computer detect "Found New hardware". This situation is call "Service Mode". When computer show
     message "found new hardware", wait 15 seconds, then press CANCEL.

7.  Download software Re-setter Canon Pixma MP237. Open software

8.  Set Destination - Region = JPN - change to Region = ASA - click SET - OK


9.    Load paper
10.  Clear Ink Counter - Absorber = MAIN - click SET - OK.
       Wait a few seconds, printer will printing D=000.0



11.  Ink Absorber Counter - Absorber = MAIN - click SET - OK

12. Turn off printer.
      Have problems when use software re-setter, read this Problems When Reset Canon Printer 
13. Turn on printer and try to printing.
      If show error "The following ink may have run out",
      press and hold STOP/RESET seven seconds (7 seconds). FINISH


Have problem to follow instruction above, watch video below. Good luck